3d skill development journal

Please download to get full document.

View again

of 22
All materials on our website are shared by users. If you have any questions about copyright issues, please report us to resolve them. We are always happy to assist you.
Categories
Published
3D Skill Development Journal Wilf Bangham Extrude (Paint Tube) The extrude tool is used for extending faces out by creating new faces. I used this on my paint tube to achieve the effect on the bottom of it being rolled up. This was done by extruding the edge, rotating the faces by 45 degrees, and the continuing to extrude the edges until I got the effect that I wanted. This was useful because it allowed my to create as complex shade easily. Extruding objects can be limiting, however, as it ca
  3D Skill Development Journal Wilf Bangham  Extrude (Paint Tube) The extrude tool is used for extending faces out by creating new faces. I used this on my paint tube to achieve the effect on the bottom of it being rolled up. This was done by extruding the edge, rotating the faces by 45 degrees, and the continuing to extrude the edges until I got the effect that I wanted. This was useful because it allowed my to create as complex shade easily. Extruding objects can be limiting, however, as it can be hard to achieve the exact form that you want when using this tool.  Smooth View The smooth view increases the amount of tris on the model, and makes the model look smooth, which means that I can model in low poly and still render the model in a high poly count. This save time as I do not have to edit a lot of polygons at the same time, instead, I only have to edit one or two of the faces to achieve a large difference. This was useful because it saved a lot of time when modelling, but was tough to use as it can alter topology that you don’t necessarily want to change, which you then need to use another tool to fix.  Insert Edge Loop The cap was quite complicated to make, and required lots of editing of edges and extrusions.  After editing the cap, altering the subdivisions messed up the model, so I instead had to insert an edge loop onto the cap so i could then achieve the effect that I wanted. This was helpful because it saved me time and ensured that I didn’t have to redo the cap. However, the tool doesn’t always detect the loop that you would want to create.
We Need Your Support
Thank you for visiting our website and your interest in our free products and services. We are nonprofit website to share and download documents. To the running of this website, we need your help to support us.

Thanks to everyone for your continued support.

No, Thanks